FORD 2011 F-150 v.1 - Manual (Page 118)

2. Open the battery cover and record the switch settings from left to
right for all 8 to 12 switches. Use the figure below:
When a switch is in the up, on, or + position, circle “L.”
When a switch is in the middle, neutral, or 0 position, circle “M.”
When a switch is in the down, off, or – position, circle “R.”
Switch position 1 2 3 4 5 6 7 8 9 10 11 12
Up, on or + L L L L L L L L L L L L
Middle, neutral or 0 M M M M M M M M M M M M
Down, off or – R R R R R R R R R R R R
L=left; M=middle; R=right
3. To input these positions into the
Car2U
௡ system, simultaneously
press all three Car2U
௡ system
buttons for a few seconds and then
release to put the device into
programming mode. The indicator
lights will blink slowly. Within
2.5 minutes enter your
corresponding DIP switch settings
from left to right into your Car2U
௡ system by pressing and releasing the
buttons corresponding to the settings you circled.
4. After inputting switch settings, simultaneously press and release all
three Car2U
௡ system buttons. The indicator lights will turn on.
Driver Controls
118
2011 F-150 (f12)
Owners Guide, 1st Printing
USA (fus)