Positive retention floor mat, Manual liftgate, Driver controls – FORD 2011 Flex v.1 User Manual

Page 112

Advertising
background image

2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink

௡ button, follow Step 1 in the Programming

section.

For questions or comments, contact HomeLink

௡ at www.homelink.com

or 1–800–355–3515.

POSITIVE RETENTION FLOOR MAT

WARNING: Do not install additional floor mats on top of the
factory installed floor mats as they may interfere with the

accelerator or the brake pedals.

Position the floor mat so that the
eyelet is over the retention post and
press down to lock in. Make sure
that the mat does not interfere with
the operation of the accelerator or
the brake pedal. To remove the floor
mat, reverse the installation
procedure.

MANUAL LIFTGATE

The liftgate area is only intended for cargo, not passengers. You can open
and close the liftgate from outside the vehicle. The liftgate cannot be
opened from the cargo area.

Note: In the event of a loss of power, the latch can be accessed and
released from the inside using the access panel on the liftgate trim.

To open the liftgate, press the
control button located in the top of
the liftgate pull cup handle to
unlatch the liftgate, then pull on the
outside handle to access the cargo
area.
• Do not open the liftgate in a

garage or other enclosed area
with a low ceiling. If the liftgate is
opened, the liftgate could be
damaged against a low ceiling.

Driver Controls

112

2011 Flex (471)
Owners Guide, 1st Printing
USA
(fus)

Advertising