FORD 2011 Taurus v.1 - Manual (Page 150)

• Horizontally mounted
• To program position 1, move the driver seat and mirrors to the desired
position using the associated controls. Press and hold button 1 for at
least two seconds. A chime will sound confirming that a memory
position has been set.
• To program position 2, repeat the previous procedure using button 2.
A memory seat position may be programmed at any time.
To program the memory feature to a remote entry transmitter, refer to
Remote entry system in the Locks and Security chapter.
A programmed memory position can be recalled:
• in any gearshift position if the ignition is not on.
• only in P (Park) or N (Neutral) if the ignition is on.
The memory positions are also recalled when you press your remote
entry transmitter
(unlock) control (if the transmitter is programmed
to a memory position) or, when you enter a valid personal entry code
that is programmed to a memory position. The mirrors will move to the
programmed position and the seat will move to the easy entry position.
The seat will move to the final position when the ignition is activated (if
easy entry feature is enabled).
Easy entry/exit feature (if equipped)
This feature automatically moves the driver’s seat rearward 2 in. (5 cm)
when:
• the transmission is in N (Neutral) or P (Park)
• the key is removed from the ignition cylinder or the push button start
system (if equipped) is switched off (refer to Push button start
system in the Driving chapter).
The seat will move to the original position when:
• the transmission is in N (Neutral) or P (Park)
• the key is placed in the ignition cylinder or when the push button
start system (if equipped) is put in accessory mode (refer to Push
button start system in the Driving chapter).
Seating and Safety Restraints
150
2011 Taurus (500)
Owners Guide, 1st Printing
USA (fus)