Tpms reset procedure, Overview, Tires, wheels and loading – FORD 2010 E-450 v.2 User Manual

Page 160

Advertising
background image

TPMS reset procedure

The TPMS reset procedure needs to be performed after each tire
rotation on vehicles that require different recommended tire
pressures in the front tires as compared to the rear tires.

WARNING: To determine the required pressure(s) for your
vehicle – refer to the Safety Compliance Certification Label or

Tire Label located on the B-Pillar or the edge of the driver’s door. See
Vehicle loading - with and without a trailer in this chapter for more
information.

Overview

Note: Before performing either of the TPMS reset procedures below
refer to Changing tires with TPMS earlier in this section to familiarize
yourself with the type of wheels and pressure sensors on your vehicle.

To provide the vehicle’s load carrying capability, some vehicles require
different recommended tire pressures in the front tires as compared to
the rear tires. The Tire Pressure Monitoring System (TPMS) equipped on
these vehicles is designed to illuminate the Low Tire Pressure Warning
indicator at two different pressures; one for the front tires and one for
the rear tires.

Since tires need to be rotated to provide consistent performance and
maximum tire life, the Tire Pressure Monitoring System needs to know
when the tires are rotated to determine which set of tires are on the
front and which are on the rear. With this information, the system can
detect and properly warn of low tire pressures.

TPMS reset tips:
• To reduce the chances of interference from another vehicle, the TPMS

reset procedure should be performed at least 3 feet (1 meter) away
from another Ford Motor Company vehicle undergoing the TPMS reset
procedure at the same time.

• Do not wait more than two (2) minutes between resetting each tire

sensor or the system will timeout and the entire procedure will have
to be repeated on all four wheels.

• A double horn chirp indicates the need to repeat the procedure.
Note: Two TPMS reset procedures are given below: one for tires with
snap-in sensors and one for tires with banded sensors.

Tires, Wheels and Loading

160

2010 Econoline (eco)
Owners Guide, 2nd Printing
USA
(fus)

Advertising
This manual is related to the following products: