Fcc and rss-210 industry canada compliance, Liftgate, Driver controls – FORD 2010 Escape v.2 User Manual

Page 86

Advertising
background image

To erase programming on the Car2U

௡ system (individual buttons cannot

be erased), use the following procedure:

1. Firmly press the two outside
Car2U

௡ system buttons

simultaneously for approximately
20 seconds until the indicator lights
begin to blink rapidly. The indicator
lights are located directly above the
buttons.

2. Once the indicator lights begin to
blink, release your fingers from the
buttons. The codes for all buttons
are erased.

If you sell your vehicle equipped with the Car2U

௡ system, it is

recommended that you erase the programming for security reasons.

FCC and RSS-210 Industry Canada Compliance

The Car2U

௡ system complies with Part 15 of the FCC rules and with

RSS-210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received including interference
that may cause undesired operation.

Changes and modifications to the Car2U

௡ system transmitter by other

than an authorized service facility could void authorization to use the
equipment.

LIFTGATE
• To open the liftgate window,

unlock the liftgate (with the
power door locks or the remote
entry) and press the right side
control button located under the
license plate lamp shield.

• To open the liftgate, unlock the

liftgate (with the power door
locks or the remote entry) and
press the middle control button
located below the license plate.

To lock the liftgate and the liftgate window, use the power door locks.

Driver Controls

86

2010 Escape (204)
Owners Guide, 2nd Printing
USA
(fus)

Advertising
This manual is related to the following products: