FORD 2010 Explorer v.2 - Manual (Page 136)

Console mount
Visor mount
1. Position the end of your hand-held transmitter 1–3 inches (2–8 cm)
away from the HomeLink
௡ button you wish to program while keeping the
indicator light in view.
2. Simultaneously press and hold both the chosen HomeLink
௡ and
hand-held transmitter buttons until the HomeLink
௡ indicator light
changes from a slow to a rapidly blinking light. Now you may release
both the HomeLink
௡ and hand-held transmitter buttons.
Note: Some entry gates and garage door openers may require you to
replace Step 2 with procedures noted in the Gate Operator and
Canadian Programming section for Canadian residents.
3. Firmly press and hold for five seconds and release the
programmed HomeLink
௡ button up to two separate times to activate the
door. If the door does not activate, press and hold the just-trained
HomeLink
௡ button and observe the indicator light.
• If the indicator light stays on constantly, programming is complete
and your device should activate when the HomeLink
௡ button is pressed
and released.
• If the indicator light blinks rapidly for two seconds and then turns
to a constant light continue with “Programming” Steps 4 through
6 to complete programming of a rolling code equipped device (most
commonly a garage door opener).
Driver Controls
136
2010 Explorer (exp)
Owners Guide, 2nd Printing
USA (fus)