Instrument cluster – FORD 2010 F-550 v.1 User Manual

Page 36

Advertising
background image

To reset the oil monitoring system to 100% after each oil change
(approximately 7,500 miles [12,000 km] or 12 months) perform the
following:

1. Press and release the SETUP button to display “OIL LIFE XXX%
HOLD RESET = NEW”.

2. Press and hold the RESET button for two seconds and release to reset
the oil life to 100%.

Note: To change oil life 100% miles value from 7,500 miles (12,000 km)
or 12 months to another value, proceed to Step 3.

3. Once “OIL LIFE SET TO XXX%” is displayed, release and press the
RESET button to change the Oil Life Start Value. Each release and press
will reduce the value by 10%.

Note: Oil life start value of 100% equals 7,500 miles (12,000 km) or
12 months. For example, setting oil life start value to 60% sets the oil
life start value to 4,500 miles (7,200 km) and 219 days.

UNITS

Displays the current units English or Metric.

Press the RESET button to change from English to Metric.

AUTOLAMP (SEC)

This feature keeps your headlights on for up to three minutes after the
ignition is switched off.

Press the RESET control to select the new Autolamp delay values of 0,
10, 20, 30, 60, 90, 120 or 180 seconds.

AUTOLOCK

This feature automatically locks all vehicle doors when the vehicle is
shifted into any gear, putting the vehicle in motion.

Press the RESET control to turn autolock on or off.

ZONE <XX> RESET = CHANGE

The compass heading is displayed as one of N, NE, E, SE, S, SW, W and
NW in the message center display.

The compass reading may be affected when you drive near large
buildings, bridges, power lines and powerful broadcast antenna. Magnetic
or metallic objects placed in, on or near the vehicle may also affect
compass accuracy.

Instrument Cluster

36

2010 F-250/350/450/550 (f23)
Owners Guide, 1st Printing
USA
(fus)

Advertising
This manual is related to the following products: