Canon ImageCLASS MF8180c - Manual (Page 16)

- 16 -
17 Make sure the machine’s power is turned on. Connect
the cable to the USB port on the back of the
machine. Then connect the other end of the cable to
the USB port on your computer.
18 When you connect the USB cable to the computer,
the machine is automatically detected as a new
hardware.
Wait for a while as your computer performs various
settings.
To Use the Machine as a Network Printer or Network FAX
(Network Connection).
IMPORTANT
• The machine needs to be restarted for the specified settings to become effective. To restart the machine,
disconnect the power cord, wait for at least 10 seconds, and connect the power cord again.
NOTE
● For details on specifying network settings, see Chapter 2, “Specifying the Network Settings,” in the Network Guide.
● For additional network protocol settings, see the Network Guide.
● For the values of the network settings, consult your network administrator or internet service provider (ISP).
Network scanning is not supported. You must be connected to the unit with a USB cable and have the USB
drivers loaded to scan. For assistance connecting the unit using USB see .