Driver controls – FORD 2008 Explorer v.3 User Manual

Page 119

Advertising
background image

Reprogramming a single HomeLink

button

To program a device to HomeLink

௡ using a HomeLink௡ button previously

trained, follow these steps:

1. Press and hold the desired HomeLink

௡ button. Do NOT release the

button.

2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink

௡ button, follow Step 1 in the “Programming”

section.

For questions or comments, contact HomeLink

௡ at www.homelink.com

or 1–800–355–3515.

STANDARD MESSAGE CENTER (IF EQUIPPED)

With the ignition in the ON position,
the message center, located on your
instrument cluster, displays
important vehicle information
through a constant monitor of
vehicle systems.
You may select
display features on the message center for a display of status. The
system will also notify you of potential vehicle problems with a display of
system warnings followed by an indicator chime.

Selectable features

Press and release the
SELECT/RESET control switch to
scroll and reset the following
functions. Select or reset the
function by holding the
SELECT/RESET button for more
than 2 seconds.

Info menu

This menu displays the following control displays:
• Odometer/Trip Odometer (Trip A and Trip B)
• Distance to Empty
• Average Fuel Economy
• Setup Menu
Odometer/Trip odometer

Refer to Gauges in the Instrument Cluster chapter.

Driver Controls

119

Advertising