FORD 2007 Edge v.1 - Manual (Page 117)

2. Press the SET control on the
driver’s door panel.
3. Within 5 seconds, press the 1 or 2
control on the driver’s door panel to
associate with the Driver 1 or Driver
2 position.
4. Press the set button again.
5. Within 5 seconds, press a button
on the associated Integrated
Keyhead Transmitter.
6. Within 5 seconds, press the 1 or 2 control on the driver’s door panel to
associate with the Driver 1 or Driver 2 position.
Deactivating the memory feature
To deactivate this feature:
1. Press the SET control on the driver’s door panel.
2. Within five seconds, press any control on the Integrated Keyhead
Transmitter which you would like to deactivate and then press the SET
control on the driver’s door panel again.
3. Repeat this procedure for another Integrated Keyhead Transmitter if
desired.
Replacing the battery
The Integrated Keyhead Transmitter uses one coin type three-volt
lithium battery CR2032 or equivalent.
To replace the battery:
1. Twist a thin coin in the slot of the
IKT near the key ring in order to
remove the battery cover.
2007 Edge (edg)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
117