Replacing brake/tail/turn/backup lamp bulbs, Replacing license plate lamp bulbs, Lights – FORD 2007 Escape v.2 User Manual

Page 51

Advertising
background image

Replacing brake/tail/turn/backup lamp bulbs

The brake/tail/turn/backup lamp bulbs are located in the tail lamp
assembly, one just below the other. Follow the same steps to replace
either bulb:

1. Make sure the headlamp switch is
in the OFF position and then open
the liftgate to expose the lamp
assemblies.

2. Remove the two screws from the
lamp assembly.

3. Carefully remove the lamp
assembly by pulling it rearward to
disengage snap features on the
outward side of the lamp.

4. Twist the bulb socket
counterclockwise and remove from
lamp assembly.

5. Pull the bulb straight out of the
socket and push in the new bulb.

6. To complete installation, follow
the removal procedure in reverse
order.

Replacing license plate lamp bulbs

1. Make sure the headlamp switch is
in the OFF position and then pry
the license plate lamp assembly
(located above the license plate)
from the liftgate.

2. Remove bulb socket from lamp
assembly by turning
counterclockwise.

2007 Escape (204)
Owners Guide (post-2002-fmt)
USA
(fus)

Lights

51

Advertising