FORD 2007 Expedition v.2 - Manual (Page 111)

1. Press and hold the two outside
buttons releasing only when the
indicator light begins to flash after
20 seconds. Do not repeat Step 1
to program additional hand-held
transmitters to the remaining two
HomeLink
௡ buttons. This will erase
previously programmed hand-held
transmitter signals into HomeLink
௡.
2. Position the end of your
hand-held transmitter 1–3 inches (2–8 cm) away from the HomeLink
௡
button you wish to program (located on your visor) while keeping the
indicator light in view.
3. Simultaneously press and hold
both the chosen HomeLink
௡ and
hand-held transmitter buttons until
the HomeLink
௡ indicator light
changes from a slow to a rapidly
blinking light. Now you may release
both the HomeLink
௡ and hand-held
transmitter buttons.
Note: Some entry gates and garage door openers may require you to
replace Step 3 with procedures noted in the “Gate Operator and
Canadian Programming” in this section for Canadian residents.
4. Firmly press, hold for five seconds and release the programmed
HomeLink
௡ button up to two separate times to activate the door. If the
door does not activate, press and hold the just-trained HomeLink
௡
button and observe the indicator light.
• If the indicator light stays on constantly, programming is complete
and your device should activate when the HomeLink
௡ button is pressed
and released.
• If the indicator light blinks rapidly for two seconds and then turns
to a constant light continue with “Programming” Steps 5 through
7 to complete programming of a rolling code equipped device (most
commonly a garage door opener).
5. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).
6. Firmly press and release the “learn” or “smart” button. (The name and
color of the button may vary by manufacturer.)
2007 Expedition (exd)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
111