FORD 2005 Taurus v.3 - Manual (Page 80)

Erasing personal codes
1. Enter the factory set 5–digit code. The keyless entry keypad and
interior lights will illuminate and the driver’s door will unlock.
2. Press and release the 1
• 2 within five seconds of completing Step 1.
3. Press and hold the 1
• 2 for two seconds to erase the customer
programmed codes.
All personal codes are now erased and only the factory set 5–digit code
will work.
Note: To exit programming mode, either wait 5 seconds after pressing 1
• 2 on the keypad, or press the 7 • 8 and 9 • 0 pads simultaneously to
lock all vehicle doors and end programming mode.
Unlocking and locking the doors using keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The headlamps, parking lamps and interior lamps will illuminate.
To unlock all doors and the liftgate (wagon), enter the factory set code
or your personal code, then press the 3
• 4 control within five seconds.
To unlock the trunk or unlock the liftgate (wagon), enter the
factory set code or your personal code, then press the 5
• 6 control
within five seconds.
To lock all doors, press the 7
• 8 and the 9 • 0 at the same time. You
do not need to enter the keypad code first.
Autolock (if equipped)
This feature automatically locks all vehicle doors when the following
conditions are met:
• all the doors are closed,
• the engine is running,
• you shift into gear, putting the vehicle in motion, and.
• the vehicle’s speed is greater than 3 mph (5 km/h).
Relock
The autolock feature repeats when the following conditions are met:
• any door is opened then closed while the engine is running, and
• you shift into gear, putting the vehicle in motion, and
• the vehicle’s speed is greater than 3 mph (5 km/h).
2005 Taurus (tau)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
80