FORD 2004 Expedition v.1 - Manual (Page 141)

Anti-scan feature
If the wrong code has been entered 7 times (35 consecutive button
presses), the keypad is disabled for one minute and the keypad lamp will
flash during this time. Note: Pressing 7
• 8 and the 9 • 0 simultaneously
during this one minute period will still lock the vehicle.
The anti-scan feature will turn off after one minute of keypad inactivity.
Unlocking and locking the doors, liftgate and liftgate window using
keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate.
To unlock all doors and liftgate, press the 3
• 4 control within five
seconds.
To open the liftgate window, press the 5
• 6 control within five
seconds.
To lock all doors, liftgate and liftgate window, press the 7
• 8 and
the 9
• 0 at the same time. Note: The driver’s door must be closed. You
do not need to enter the keypad code first.
Activating/deactivating autolock with the keyless entry system
1. Turn the ignition to the OFF position.
2. Close all the doors, the liftgate and liftgate window.
3. Enter 5–digit entry code
4. Press and hold the 7
• 8. While holding the 7 • 8 press the 3 • 4.
5. Release the 3
• 4.
6. Release the 7
• 8.
The user should receive a horn chirp to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.
SECURILOCK ி PASSIVE ANTI-THEFT SYSTEM
SecuriLock
௢ passive anti-theft system is an engine immobilization
system. This system is designed to prevent the engine from being started
unless a coded key programmed to your vehicle is used.
The SecuriLock
௢ passive anti-theft system is not compatible with
non-Ford aftermarket remote start systems. Use of these systems may
result in vehicle starting problems and a loss of security protection.
2004 Expedition (exd)
Owners Guide (post-2002-fmt)
USA English (fus)
Locks and Security
141