Roadside emergencies – FORD 2004 Expedition v.2 User Manual

Page 255

Advertising
background image

2. Remove the jack and tools assembly tray from the compartment by
turning the wing-nut counterclockwise to relieve tension against the jack
assembly tray.
3. Unsnap the wheel lug nut wrench, jack extension and handle from the
plastic tray. Remove the jack and instruction sheet from the tray
assembly.
Removing the spare tire

1. Fold the rear seat down. Refer to
Rear seats in the Seating and
safety restraints
chapter.

2. Remove the jack handle and
winch extension from the tray and
assemble them.

3. Open the spare tire winch access
plug in the bottom of the
compartment located behind the 3rd
row seat, very close to the jack and
tools tray.

4. Insert the winch extension tool
assembly through the access hole in
the floor and engage the winch.

5. To remove the spare tire, turn the handle counterclockwise until the
tire is lowered to the ground and the cable is slightly slack.
6. Slide the retainer through the center of the spare tire wheel.
Tire change procedure

To help prevent the vehicle from moving when you change a tire,
be sure the parking brake is set, then block (in both directions)

the wheel that is diagonally opposite (other side and end of the
vehicle) to the tire being changed.

If the vehicle slips off the jack, you or someone else could be
seriously injured.

On vehicles equipped with Air Suspension, turn OFF the Air
Suspension switch prior to jacking, hoisting or towing your

vehicle.

2004 Expedition (exd)
Owners Guide (post-2002-fmt)
USA English
(fus)

Roadside Emergencies

255

Advertising