FORD 2004 F-150 v.3 - Manual (Page 90)

Perimeter lighting feature (if equipped)
The perimeter lighting feature illuminates the exterior of the vehicle in
order to provide better visibility to the user while he or she approaches
and enters the vehicle.
The perimeter lighting feature activates when:
• the ignition is in the 1 (OFF/LOCK) position,
• the autolamp sensor determines that it is dark, and
• the user activates an unlock feature, using either the remote keyless
transmitter or the keypad.
The perimeter lighting feature will illuminate the headlamps and parking
lamps for 25 seconds, or until:
• the ignition is turned to any position other than the 1 (OFF/LOCK)
position, or
• the user activates a lock feature, using either the remote keyless
transmitter or the keypad.
Enabling/disabling the perimeter lighting feature
Your vehicle comes with the perimeter lighting feature enabled. To
disable or re-enable this feature, perform the following steps within 30
seconds:
1. Turn the ignition to the 3 (ON) position, then press the control
three times.
2. Turn the ignition to the 1 (OFF/LOCK) position, then press the
control three times.
3. Turn the ignition to the 3 (ON) position, and within five seconds,
press the
control two times. A short horn chirp followed by a long
horn activation confirms that the perimeter lighting feature has been
enabled. A short horn chirp by itself confirms that the feature has been
disabled.
4. Pressing the power door control two times again will turn the
feature ON if it was previously OFF, or OFF if it was previously ON.
Every two consecutive presses of the
control after successfully
entering the configuration mode will change the enable/disable condition
of the feature.
5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming.
Autolock (if equipped)
The autolock feature will lock all the doors when:
• all the doors are closed,
2004 F150 (f12)
Owners Guide (post-2002-fmt)
USA English (fus)
Locks and Security
90