FORD 2004 Focus v.2 - Manual (Page 114)

TRACTION CONTROL ி (IF EQUIPPED)
Your vehicle may be equipped with a Traction Control
௢ system. This
system helps you maintain the stability and steerability of your vehicle,
especially on slippery road surfaces such as snow- or ice-covered roads
and gravel roads. The system will allow your vehicle to make better use
of available traction in these conditions.
During Traction Control
௢ operation,
the traction control active light will
illuminate, you may hear an electric
motor type of sound coming from
the engine compartment and the
engine will not “rev-up” when you push further on the accelerator. This
is normal system behavior and should be no reason for concern.
At speeds below 85 km/h (53 mph), both the engine and the brake
system will be used to control wheel spin; at speeds above 85 km/h (53
mph), only engine torque reduction is used. When the Traction Control
௢
system is switched off, the braking system will still be used to control
wheel spin at speeds below 40 km/h (25 mph).
The Traction Control
௢ switch is
located on the center console, by
the gearshift lever. The Traction
Control
௢ system will automatically
turn on every time the ignition is
turned off and on.
If you should become stuck in snow
or ice or on a very slippery road
surface, try switching the Traction Control
௢ system off by pressing the
switch. This may allow excess wheel spin to “dig” the vehicle out and
enable a successful “rocking” maneuver. If you want to turn off the
Traction Control
௢ system be aware that, for safety reasons, the switch
must be pressed and held for at least one second before the system is
turned off.
If a system fault is detected, the traction control active light will
illuminate, the Traction Control
௢ button will not turn the system on or
off and your vehicle should be serviced.
2004 Focus (foc)
Owners Guide (post-2002-fmt)
USA English (fus)
Driving
114