FORD 2004 Taurus v.1 - Manual (Page 57)

5. Press and hold the RESET until
the message center display changes
to show the current zone setting.
6. Release the RESET control, then
slowly press RESET down again.
7. Press the SET control repeatedly
until the correct zone setting for
your geographic location is
displayed on the message center. To exit the zone setting mode press
and release the RESET control.
8. Press the RESET control to start
the compass calibration function.
9. Slowly drive the vehicle in a
circle (less than 5 km/h [3 mph])
until the CIRCLE SLOWLY TO
CALIBRATE indicator changes to
CALIBRATION COMPLETED. This
will take up to three circles to complete calibration.
10. The compass is now calibrated.
Outside air temperature (if equipped)
Press INFO button for 2 seconds to
display the outside temperature. To
switch from temperature display to
the compass display hold the INFO
button for 2 seconds.
To turn the display off or change
the display from English to metric see your dealer.
2004 Taurus (tau)
Owners Guide (post-2002-fmt)
USA English (fus)
Driver Controls
57