FORD 2003 Excursion v.1 - Manual (Page 81)

Erasing personal code
1. Enter the factory set 5–digit code.
2. Press and hold the 1
• 2 for two seconds. This must be done within
five seconds of completing step 1.
3. Press the 7
• 8 and the 9 • 0 at the same time. This must be done
within five seconds of completing step 2.
Your personal code is now erased and only the factory set 5–digit code
will work.
Unlocking and locking the doors using keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate after pressing the first control on
the keypad.
To unlock all doors, press the 3
• 4 control within five seconds.
To lock all doors, press the 7
• 8 and the 9 • 0 at the same time. You
do not need to enter the keypad code first. Note: The interior lamps
will turn off.
Autolock (if equipped)
This feature automatically locks all vehicle doors when the following
conditions are met:
• the ignition key is in the RUN position,
• all the doors are closed,
• the brake is pressed before reaching 8 km/h (5 mph), and
• the vehicle is traveling more than 8 km/h (5 mph).
Relock
The autolock feature repeats when the following conditions are met:
• the vehicle’s speed is less than 8 km/h (5 mph),
• any door is opened then closed while the ignition is in the RUN
position,
• the brake is pressed before reaching 8 km/h (5 mph), and
• the vehicle is traveling more than 8 km/h (5 mph).
To deactivate/reactivate the autolock feature using the keypad
Your vehicle comes with the autolock feature activated. To
deactivate/reactivate this feature:
Locks and Security
81