Locks and security – FORD 2003 Expedition v.1 User Manual

Page 133

Advertising
background image

Programming remote transmitters

It is necessary to have all (maximum of four — original and/or new) of
your remote transmitters available prior to beginning this procedure.

To program the transmitters yourself:
• Unlock all the doors.
• Insert a key in the ignition and

turn from 1 (OFF) to 3 (ON) and
cycle between 1 (OFF) and 3
(ON) eight times in rapid
succession (within 10 seconds)
with the eighth turn ending in the
3 (ON) position. The locks will
cycle once to confirm that
programming mode has been
entered.

• Within 20 seconds, program a remote transmitter by pressing any

button on a transmitter. The locks will cycle once to confirm that the
remote transmitter has been programmed. (If more than 20 seconds
pass before pressing a remote transmitter button, the programming
mode will exit and the procedure will have to be repeated.)

• Repeat the previous step to program additional remote transmitters.

The locks will cycle once to confirm that each remote transmitter has
been programmed.

• When you have completed programming the remote transmitters, turn

the ignition to 1 (OFF) or wait 20 seconds. Again the doors will
lock/unlock to confirm programming has been completed.

Illuminated entry

The lamps illuminate when the remote entry system is used to unlock
the door(s).

The system automatically turns off after 25 seconds or when the ignition
is turned to the ON or ACC position. The dome lamp control must not
be set to the OFF position for the illuminated entry system to operate.

The inside lights will not turn off if:
• they have been turned on with the dimmer control, or
• any door is open.
The battery saver will shut off the interior lamps 30 minutes after the
ignition has been turned to the OFF position.

4

3

2

1

Locks and Security

133

Advertising