FORD 2003 Explorer Sport Trac v.1 - Manual (Page 53)

1. Press and hold the MODE
control until “VAR” appears in the
display. The current location
number should be displayed.
2. Press the MODE control
repeatedly until your desired
location number appears in the
display. Use this zone map to
determine which location number
you should be using.
• Adjusting the calibration of the compass
Note: To adjust the calibration find an open area free from steel
structures and high voltage lines.
1. Press and hold the MODE
control until “CAL” appears in the
display then release the control.
2. Drive slowly (less than 5 km/h
[3 mph]) in circles until “CAL”
disappears from the display
(approximately 2 or 3 circles).
LAMP MODE LAMP
9 VAR
1 2 3
4
5
6 7 8 9 1011
12
13
14
15
LAMP MODE LAMP
CAL
Driver Controls
53