Closet Maid 6605 - Manual

Part Chart
Support Brackets needed per shelf:
Shelf Length 4’
1.2m
6’
1.8m
8’
2.4m
12’
3.7m
Wall to Wall Pared a pared
1 1 2 3
Wall to Open Pared a borde
2 2 3 4
Open to Open Borde a borde
3 3 4 5
6605
1
2
3
75381 06605
0 1
01-84640
Consumer Toll-Free Help Line
1-800-874-0008
(U.S.A and Canada)
www.closetmaid.com
Manufacturer reserves the right to change
specifications without notice.
Made in USA
© ClosetMaid Corporation 2004
Ocala, FL 34478-4400
If a ClosetMaid® product does not give
user complete satisfaction when installed in
accordance with manufacturer's
instructions, it will be exchanged free of
charge. Only the unsatisfactory part in a
multi-piece product will be exchanged.
Push pre-loaded anchor into drilled hole. Use bottom of hammer
handle to push in pin. For removal, pry pin out with screwdriver.
Empuje el tarugo preinstalado dentro del orificio perforado. Use
la parte inferior del mango del martillo para empujar la clavija
hacia adentro. Para remover, palanquee la clavija sacándola con
un destornillador.
Level shelf. Drill 1/4" hole through wall using bracket as guide. DO
NOT PUNCH HOLES. Space support brackets every 3’.
Nivele la repisa. Perfore un orificio de 6 mm a través de la pared usando
el soporte como guía. USE TALADRO UNICAMENTE. Coloque los soportes
a cada 91,5 cm de distancia.
Position support bracket on shelf as shown.
Coloque el soporte en la repisa tal como se muestra.