Locks and security – FORD 2002 Ranger v.3 User Manual

Page 108

Advertising
background image

Sounding a panic alarm

Press this control to activate the
alarm.

To deactivate the alarm, press the
control again or turn the ignition to
ACC or ON.

Panic alarm will only operate with
the ignition in the OFF position.

Replacing the battery

The transmitter is powered by one coin type three-volt lithium battery
CR2032 or equivalent. Typical operating range will allow you to be up to
10 meters (33 feet) away from your vehicle. A decrease in operating
range can be caused by:
• Weather conditions
• Nearby radio towers
• Structures around the vehicle
• Other vehicles parked next to the vehicle
To replace the battery:

1. Twist a thin coin between the two
halves of the transmitter near the
key ring. DO NOT TAKE THE
FRONT PART OF THE
TRANSMITTER APART.

2. Place the positive (+) side of new
battery in the same orientation.
Refer to the diagram inside the
transmitter unit.

3. Snap the two halves back
together.

Locks and Security

108

Advertising