FORD 2002 Taurus v.3 - Manual (Page 89)

Deactivating/activating perimeter lamps
There are 2 methods to enable/disable this feature. One through your
dealer and the second with a power door lock sequence using the
following instructions:
1. Turn the ignition key to RUN, then press the power door UNLOCK
control button 3 times.
2. Turn the ignition key to OFF, then press the power door UNLOCK
control button 3 times.
3. Turn the ignition key to RUN, within five seconds press the power
door UNLOCK control button 2 times.
The user should receive two horn chirps to indicate the system had
been altered.
Note: Puddle lamps cannot be deactivated, only the head, park, and tail
lamps will be deactivated/activated.
• Turn ignition to OFF to exit.
KEYLESS ENTRY SYSTEM (IF EQUIPPED)
With the keyless entry keypad, you
can:
• lock or unlock the vehicle doors
and liftgate (wagons) without using the key.
• open the trunk.
• arm and disarm the perimeter alarm system (if equipped).
See also Remote entry system and Perimeter alarm system in this
chapter for more information.
Your vehicle has a factory-set 5–digit code that operates the keyless
entry system. You can also program your own 5–digit personal entry
code.
The factory-set code is located:
• On the owner’s wallet card in the glove compartment,
• On the inner side of the passenger compartment fuse box, or
• At your dealer.
When using the keyless entry keypad, press the middle of each button in
order to ensure a good activation.
1 2 3 4 5 6 7 8 9 0
Locks and Security
89