FORD 2001 Crown Victoria - Manual (Page 34)

Temperature conversion
Press MAX A/C and DEF at
the same time (for one second) to
switch between Fahrenheit and
Celsius.
If your vehicle has an English/Metric (E/M) control to change your
electronic instrument cluster display (if equipped) and the message
center display (if equipped) from English to Metric, this control will also
change the temperature display. Refer to Electronic Message Center in
the Instrumentation Chapter.
Fan speed ( )
When AUTOMATIC is pressed, fan
speed is adjusted automatically for
existing conditions. You can override
fan speed at any time. To control
fan speed manually, use the
thumbwheel to cancel automatic fan
speed operation. Rotate the
thumbwheel up for higher fan speed
or down for lower fan speed.
The display will show to
indicate manual fan operation.
To return to automatic fan operation, press AUTOMATIC.
Manual override controls
The override controls are located at
the bottom of the EATC and allow
you to determine where airflow is
directed. To return to full automatic
control, press AUTOMATIC.
The air conditioning compressor can operate in all modes except FLOOR
and VENT. It will also operate only when required when AUTOMATIC
has been selected. However, the air conditioning will only function if the
outside temperature is about 6°C (43°F) or higher.
NORM A/C VENT FLOOR FLR • DEF DEF
HI
LO MAX A/C
OUTSIDE TEMP AUTOMATIC
OFF
AUTO
FLR • DEF DEF
HI
LO
AUTOMATIC
OFF
˚ F
AUTO
NORM A/C VENT FLOOR FLR • DEF DEF
HI
LO MAX A/C
OUTSIDE TEMP AUTOMATIC
OFF F
AUTO
Controls and features
34