Seating and safety restraints – FORD 2001 Windstar User Manual
Page 128
To install the seat:
1. Remove (if necessary) tub covers from the floor to expose the seat
mounts.
• To remove the tub cover(s), use a
screwdriver to pry the tub cover
(where indicated) upward and
out of the floor tub.
• To install the tub cover(s), first
insert the tabs located on the
opposite side of the pry location
into the slots of the floor tub then
press down on the other side of
the cover until it snaps into place
securely. (Additional tub covers
can be purchased as an accessory
from your dealer.)
2. Position the seat in the vehicle.
The second row bench or bucket console seat may be indexed to be
positioned to either the far left or right hand side of the vehicle. (4-door
vehicles only). The left side of the figure is the front of the vehicle.
• Indexed to far left
Seating and safety restraints
128