Hella Micro DE Premium Xenon - Manual (Page 9)

Page 5
Replacing the xenon bulb
IMPORTANT!
The electrical connection between
headlamp and ballast carries high
voltage and must not be
disconnected.
Always switch off the headlamp
before changing the bulbs and
disconnect from the power supply.
Never insert foreign objects or
fingers into the plug.
Safety instructions
9
A final tip:
Keep the cover lenses clean.
Dirt can absorb up to 80% of
the light output.
Do you carry reserve bulbs and
fuses in your car?
If you have any questions or
installation problems,: Contact
your Hella stockist.
Reassemble and tighten headlamp
parts.
Dispose of used xenon bulbs as
hazardous waste.
Check function and adjustment of
the headlamps.
The ballast must never be operated
without a bulb, as dangerous
voltage spark-over, which leads to
damage, may occur at the plug.
Allow the bulb to cool off.
Wear safety goggles and gloves
when changing bulb.
The glass body of the xenon bulb is
filled with various gases and metal
gases under pressure (danger of
splintering).
Never touch the glass bulb of the
xenon lamp, touch the bulb at its
base only. Use a clean cloth and alcohol to
remove any fingerprints from the
glass bulb.
Only operate the bulb in a closed
headlamp.
1. Screw connection plug and
remove.
2. Loosen screw and remove
bracket.
3. Replace illuminant.
Have the driving lamps adjusted
at a workshop or service station.
Only properly adjusted lamps
provide optimum illumination.