Hella Jumbo 320 FF Halogen Fog - Manual (Page 8)

8 • Ruler
• Combination pliers
• Pliers for crimp connectors
(if available)
Page 3: Mounting steps
• 17 mm open end or box wrench
• Drill with 3, 5, 6, 11 and 12 mm
dia. bits
• 3 and 6 mm Allen keys
Determine mounting position on flat
surface and mark mounting points.
Drill pilot hole with 3 mm dia. bit and
then bore out to 11 mm.
Protect drilled metal parts with rust
protection paint.
Preliminarily install mount.
Open housing and install bulb.
Do not touch bulbs with bare fingers!
Use tissue paper or similar.
Assemble housing.
Screw holder and housing together
and route cable cleanly.
Screw lamps to vehicle (use two-
point mount if required).
Align lamps and tighten screws.
Tools required:
Attachment dimensions:
For upright/pendant mounting,
above/below bumper. Lamps
should neither vibrate nor extend
higher than the bonnet and must
be fitted symmetrically.
(also see
”One more tip”)
The table shows the possibilities
permitted in the various countries:
D C C
A
B