Hella 450 Fog - Manual (Page 8)

Probedruck
C M Y CM MY CY CMY K
8
ENGLISH GB
Tools: • Folding rule
• Pliers for crimp connectors
• Chisel
• Crosshead screwdriver • Screwdriver
• Open-end/Ring spanner
13, 17, 19
• Drill bits Ø 3, 11 mm
Page 5: Electrics Caution! – Ignition in zero position.
Install the Hella relays (available
from accessory dealers) in a
splash-proof position, with the
connection terminals pointing downwards. Lay the cables and
connect them in accordance
with circuit diagram B. Connect
terminal 86 of the second relay
to the existing reverse light.
Page 3 and 4: Installation Pendant or upright installation
is possible. The light must not
protrude beyond the edge of
the vehicle. (see page 4, Fig.: A)
1. Determine the installation
position (Fig.: 1) and mark the
fastening points.
2. Pilot-drill using a 3 mm drill bit,
and drill out to 11 mm. Seal
drilled metal parts with rust
protection.
3. Remove the light insert. Push
blade terminals onto the cables
and crimp together. Insert the bulb
and the sealing grommet in
accordance with the instructions.
Assemble the housing according
to the chosen position.
4. Align and tighten the light
according to the chosen mounting
location (Fig.: 2 and 3).