Hella Micro DE Halogen Fog User Manual

Page 10

Advertising
background image

10

1. Determine mounting position
and mark mounting points accor-
ding to attachment dimensions
given above.

2. Drill pilot hole with 3 mm dia.
bit and then bore out to 8 mm.
Protect drilled metal parts with rust
protection paint.

Attachment dimensions:

For upright/pendant mounting.
Lamps should neither vibrate nor
extend higher than the bonnet and
must be fi tted symmetrically.

Tools required:

Mounting steps:

3. Remove lamp set, press rubber
grommet in from inside and install
stabilization ring (Fig.1; 2).

4. Preinstall bracket and tighten
bolts hand-tight.

1. Adjusting frame

Accessories, see Fig. page 6

(not included with kit)

• Ruler

• Combination pliers

• 10 mm open-end or box wrench

• Drill with 3, 8, 12 mm dia. bits

• Screwdriver for recessed-head

screws

D

C

C

A

B

(also see
”One more tip”)

The table shows the possibilities
permitted in the various countries:

2. Wiring harness with relay

Advertising
This manual is related to the following products: