Crown Audio CROWN K Series - Manual (Page 8)

K Series Power Amplifiers
page 8 Operation Manual
3.6.5 “Y” Mono Input to Dual
Outputs
If you want to feed a mono audio signal to two
channels, each with its own level control, set
the “Y” Input switch ON. This connects both
inputs in parallel. You might use this setup if
you’re running a monitor speaker on one chan-
nel and a main speakers stack on the other
channel, and you want to feed them the same
signal.
See Figure 3.10.
INPUTS: Connect input wiring to one channel.
OUTPUTS: Maintain proper polarity (+/-) on
output connectors.
Connect Channel 1 positive (+) speaker load to
Channel 1 positive terminal of amp; repeat for
negative (-). Repeat Channel 2 wiring as for
Channel 1.
3.6.6 “Y” Mono Input to Bridge-
Mono Output
If you want daisy-chained inputs fed to a dou-
ble-voltage output, set the Bridge Output switch
ON and the “Y” Input switch ON.
See Figure 3.11.
For example, connect the input signal to the
CH-1 XLR connector and use the CH-2 XLR
connector plus the two 1/4-inch phone jacks
for daisy-chained outputs that feed other power
amplifiers.
NOTE: Crown provides a reference of wiring pin
assignments for commonly used connector
types in the Crown Amplifier Application Guide
available on the web at www.crownaudio.com.
CH 2 CH 1
CH 2 CH 1
Figure 3.10
Wiring for “Y” Mono Input,
Dual Output
Figure 3.11
Wiring for “Y” Mono Input ,
Bridge-Mono Output