Chrysler Uconnect for Jeep - Manual (Page 10)

system. Only one linked (or paired) cellular phone can be
used with the system at a time. The system is available in
English, Spanish, or French languages.
Uconnect™ Phone Button
The radio will contain the two control buttons
(Phone
Button and Voice Command
button) that will enable you to access the
system. When you press the button you will
hear the word Uconnect™ followed by a BEEP. The beep
is your signal to give a command.
The first time the Phone button is pressed during a drive
cycle, the connected phone will be announced. Ex.
“Uconnect™, Jerry’s phone is connected.”
NOTE: If nothing is said within a few seconds, the
system will present a list of menu options. Listen to the
choices and give your command after the beep.
Voice Command Button
Actual button location may vary with the ra-
dio. The individual buttons are described in the
“Operation” section.
The Uconnect™ Phone can be used with any Hands-Free
Profile certified Bluetooth
௡ cellular phone. See the
Uconnect™ website for supported phones. If your cellu-
lar phone supports a different profile (e.g., Headset
Profile) you may not be able to use any Uconnect™
Phone features. Refer to your cellular service provider or
the phone manufacturer for details.
The Uconnect™ Phone is fully integrated with the vehi-
cle’s audio system. The volume of the Uconnect™ Phone
can be adjusted either from the radio volume control
knob or from the steering wheel radio control (right
switch), if so equipped.
2
Uconnect™ Phone 9