Ram Trucks uconnect 5.0 for Chrysler - Manual (Page 18)

play when you insert the device. The display will show
the track number, and index time in minutes and sec-
onds. Play will begin at the start of track 1.
Browse
Touch the “Browse” soft-key to select Artist, Albums,
Genres, Songs, Playlists or Folders from the USB/iPod®
device. Once the desired selection is made you can chose
from the available media by touching the soft-key. Touch
the “Exit” soft-key if you wish to cancel the browse
function.
AUX Mode
AUX Mode is entered by inserting a AUX device using a
cable with a 3.5 mm audio jack into the AUX port or by
touching the MEDIA hard-key located left of the display.
Once in Media Mode, touch the “Source” soft-key and
select AUX.
Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX
Port. If you insert a Auxiliary device with the ignition
ON, the unit will switch to AUX mode and begin to play
when you insert the device cable.
Controlling the Auxiliary Device
The control of the auxiliary device (e.g., selecting play-
lists, play, fast forward, etc.) cannot be provided by the
radio; use the device controls instead. Adjust the volume
with the VOLUME rotary knob, or with the volume of the
attached device.
The vehicle radio unit is acting as the amplifier for audio
output from the Auxiliary device. Therefore if the volume
control on the Auxiliary device is set too low, there will be
insufficient audio signal for the radio unit to play the
music on the device.
3
MEDIA MODE 17