Chief Manufacturing Small Flat Panel In-Wall Swing Arm Mount FWDIW-I Series - Manual (Page 4)

FWDIW Series Installation Instructions
4
Installation
The following procedure assumes that a Chief Model FAC501
In-Wall accessory has previously been installed following the
installation instructions provided by the manufaurer. If a
FAC501 is not installed or there are any other questions
regarding the installation of this accessory, immediately contact
Chief.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! DO NOT deviate from
installation instructions provided. DO NOT substitute
hardware.
Install Bumper
1. Install two bumpers (G) to bumper mounting bracket (F).
(See Figure 1)
NOTE: A screwdriver may be required to push bumper into
hole in bumper mounting bracket.
2. Secure bumper mounting bracket (F) to FAC501 onto the
side the arm will be located when retracted using two
Phillips pan head screws (K). (See Figure 1)
Figure 1
3. Align bottom of swing arm pivot pin with hole in lower
support plate. (See Figure 2)
4. Lower swing arm until pivot pin rests in hole in lower support
plate. (See Figure 2)
5. Align four mounting holes in swing arm mounting bracket
with four mounting holes in FAC501. (See Figure 2)
Figure 2
6. Secure swing arm to FAC501 using four button head cap
screws (C), four lock washers (D) and four flat washers (E).
NOTE: The mounting holes in the swing arm monting bracketd
are slotted horizontally to allow the mount to be slighlty
off-center to provide better cable clearance.
Figure 3
(F) x1
(G) x2
(K) x2
2
1
Lower Support Plate
Swing Arm
Mounting
Bracket
4
3
5
(C) x4 (E) x4
(D) x4
6