CTX PV722E - Manual (Page 15)

PV722E User’s Manual
15
Recommended Use of the Monitor
Power
Use the type of power indicated on the marking label.
Plugs
Do not remove any of the prongs of the monitor's three-pronged power plug.
Disconnect the power plug from the AC outlet if you are not going to use it for
an indefinite period of time.
Power cords
Use the proper power cord with correct attachment plug type. If the power
source is 120 V AC, use a power cord that has UL and CSA approvals. If the
power source is a 240 V AC supply, use the tandem (T blade) type
attachment plug with ground conductor power cord that meets the respective
European country's safety regulations, such as VDE for Germany.
We recommend using the power cord supplied with the product. However, if
another type of power cord is required power cord H05VV-F or VW-1,
18AWG x 3G should be used.
Do not overload wall outlets or power cords. Ensure that the total of all units
plugged into the wall outlet does not exceed 7 amperes.
Ensure that the total ampere ratings on all units plugged into the extension
cord is not above the cord's rating.
If the power supply cord which came with your monitor is to be connected to
the PC instead of the wall outlet, this equipment should be used with UL/TUV
approved computers with receptacle rated 100~240V AC, 50/60Hz, 1.0A
(minimum).
Do not allow anything to rest on the power cord. Do not locate this product
where persons will walk on the cord.