Cuisinart Compact 2-Slice Toaster CPT-122 - Manual (Page 5)

5
4. Press the Defrost button. LED indicates feature is
activated.
To stop cycle
When the defrost cycle is complete, the toaster will raise the bread.
If you wish to stop the cycle before it is finished, simply press the
Cancel button to interrupt.
After use, unplug the toaster from the electrical outlet.
Reheat button
The reheat feature allows you to reheat bread without browning
or toasting it.
1. Insert slice(s) of bread.
2. To begin toasting
Press the carriage lever until it locks into the down position.
3. Press the Reheat button. LED indicates feature is activated.
To stop cycle
4. When the reheat cycle is complete, the toaster will raise the
bread. If you wish to stop the cycle before it is finished, simply press
the Cancel button to interrupt.
Bagel button
The bagel feature adds extra time to the toasting cycle to allow for thick-
er breads. You may also use the bagel button for English muffins and
other thick breads.
1. Insert slice(s) of bread or halved bagels.
Be sure that multiple slices do not overlap and the carriage is in the
up position.
2. Press the carriage control lever until it locks into position.
3. Press the Bagel button to start. Red LED indicates feature is
activated.
To stop cycle
When the bagel cycle is complete, the toaster will raise the bread. If
you wish to stop the cycle before it is finished, simply press the
Cancel button to interrupt.
CLEANING AND MAINTENANCE
Always allow the toaster to cool completely before cleaning.
1. Always unplug the toaster from the electrical outlet before cleaning.
2. Do not use abrasive cleansers. Simply wipe the exterior with a clean
damp cloth and dry thoroughly. Apply any cleansing agent to a cloth,
not to the toaster, before cleaning.
3. To remove crumbs, slide out the crumb tray and discard crumbs.
Wipe clean and replace. Never operate the toaster without the crumb
tray in place.
4. To remove any pieces of bread remaining in the toaster, turn the
toaster upside down and gently shake. Never insert any hard or
sharp instruments into the slot, as this could damage the toaster and
cause a safety hazard.
5. Never wrap the cord around the outside of the toaster. Use the cord
storage cleats on the underside of the toaster.
6. Any other servicing should be performed by an authorized service
representative.