Esselte LECTRA TAG QX50 - Manual (Page 5)

How to use your
DYMO LetraTag
Thank you for choosing the DYMO LetraTag
for your labeling needs.
Install Batteries
1. On the back of the unit, push the tab and lift
the battery compartment cover off (fig. A).
2. Match the + and – marks on the batteries
to the + and – marks in the battery com-
partment case and insert 5 “AA” alkaline
batteries. Start with the single battery in
the upper slot, then slide the second and
third under the bridge. Slot in the fourth
and fifth batteries.
3. Press the battery cover back into place.
Remove the batteries if the unit is to remain
unused for an extended period of time.
Inserting the Tape Cassette
1. Press the tab on the front side of the
cassette cover (figure B) and open cover.
Insert the cassette, the cassette inserts
with the tape exiting to the top of the
machine. Gently press on the center of the
tape until it clicks into position.
2. Close the cassette cover.
Display
The display will show 9 characters including
the cursor and feature indicators that are
highlighted when a feature is activated.
Feature indicators include:
CAPS Characters are typed as capital letters
lQ-Rl Fixed length is activated
B
The label will be print in BIG FONT
ABC The label will be printed in a certain
type of box
STYLE The label will print with the style
selected
123 Number lock
ABC The text will be underlined
If an incorrect key sequence is pressed, the
display will flash.
Function Keys
ON/OFF
Turns the unit on or off. When turning
the unit on, a DYMO welcome screen will be
displayed for a few seconds. The unit will auto-
matically turn off after 2 minutes if no keys
are pressed. The last label will be saved and
displayed when the unit is turned on again.
Note: If the batteries are removed for more
than a few seconds the text and settings will
not be saved.
5
US