Channel Vision IC812 - Manual (Page 2)

2
Model IC812
Installation:
h
h
h
h
h
h
Use the provided template to mark and cut a ” hole in
drywall away from ceiling joists.
We recommend wiring with AWG 16 or larger, stranded
wire.
For proper phasing, both speakers must be wired alike.
Connect red wires to red terminals on the speakers and
to red or plus terminals on the amplifier.
Aim tweeter
To control the volume of the speaker locally, use an
impedance matching volume control, such as the
Channel Vision VC300.
9-½
Install IC812 in the hole. Tighten the mounting screws.
The mounting “dogs ears” will rotate outward and grip the
drywall.
the screws. A battery
operated drill on a “low clutch” setting is recommended.
DO NOT OVER TIGHTEN
Mounting screws (4)
3
Features:
8” High performance in-ceiling loudspeaker
High power handling capacity
Gold speaker terminals
Proprietary pivoting “Pole Piece” technology with 1” voice
coil.
Polypropylene woofer with butyl rubber surround and an 18
ounce magnet
Small perforated designer grille
Recommended power: 20W to 180W (peak)
Specifications:
Frequency range:
Crossover:
Sensitivity:
Power Handling:
Drivers:
Magnet:
Impedance:
Finish:
Dimensions:
35Hz - 20kHz ± 6dB
12dB/octive (low pass)
12dB/octive (high pass)
91dB (1W/1m)
180 Watts peak
1- 1” Soft dome tweeter
1- 8” polypropylene woofer
24-ounce ferrite magnet
8 ohms
ABS plastic
10 OD. 4-½ height
(from surface of wall board)
hole size: 9 diameter
-¾” ”
-½”
Specifications subject to change without notice.