Coda 10.5 - Manual (Page 8)

BRIDGED operation consists of one AMPLIFIER 10.5 per channel. The amount of power
from a stereo AMPLIFIER 10.5 is 100 Watts with 25 Watts class A per channel. A bridged
AMPLIFIER 10.5 is 400 Watts with 25 Watts class A per chassis. To bridge, set the MODE
switch on the back of the amplifier to the BRIDGED position.
NOTE: TURN THE MAIN AC POWER
SWITCH ON THE BACK OF THE
AMPLIFIER 10.5 OFF BEFORE
ALTERING THE MODE SWITCH
OR CONNECTING OR
DISCONNECTING ANY CABLES.
The bridging switch commons the inputs of the AMPLIFIER 10.5, were pin 2 of the left XLR
commons with pin 3 of the right XLR, and pin 2 of the right XLR commons with pin 3 of the
left XLR. Whichever input is used the output of that channel will be the positive signal and
the channel which has no input will be the negative signal.
The set up diagram for BRIDGED operation is on the following page.
DETAILED INSTALLATION 7
III. BRIDGED SETUP
WARNING: DO NOT OPERATE THIS AMPLIFIER WITH THE TOP COVER REMOVED. NEVER MAKE
ANY INTERNAL ADJUSTMENTS WHILE THIS AMPLIFIER IS CONNECTED TO AN AC POWER SOURCE.
BRIDGED
STEREO
MODEL
SERIAL NUMBER
MODE
Back of AMPLIFIER 10.5