Cobra Electronics MICROTALK CXR925 - Manual (Page 6)

Customer Assistance Warranty Introduction
7
Operation
6
Using Your Radio
Auto Squelch/Maximum Range
•
Your microTALK ® radio is equipped with Auto Squelch, which
automatically shuts off weak transmissions and unwanted noise
due to terrain and conditions. This slightly reduces the Maximum
Range at which signals can be heard.
You can turn off auto squelch to allow all signals to be
received and extend the maximum range of your radio.
To briefly turn off auto squelch:
– Press the Light/Max Range button
for less than five (5) seconds.
If you hear two (2) beeps, you have turned
the maximum range extender on (see below).
To turn maximum range extender on:
– Press and hold the Light/Max Range button
for at least five (5) seconds until you hear
two (2) beeps which indicates the maximum
range extender is on.
To turn maximum range extender off:
– Press and release the Light/Max Range
button or change channels.
Lock Feature
•
The Lock feature locks the Channel, Mode, Hi•Low and Power
buttons to prevent accidental operation.
To turn the lock feature on or off:
– Press and hold the Lock/Enter button for
two (2) seconds.
A double beep sound is used to confirm your
lock on or off request. When in Lock mode,
the Lock icon will be displayed.
Operation
Light/Max Range
LI 7300
Lock/Enter Button
Lock Mode
Speaker/Microphone/Charge Jack
•
Your microTALK ® radio can be fitted with an external Speaker/Microphone,
freeing your hands for other tasks. This same jack also serves as the
connecting point for the wall charger/adapter.
To attach a speaker/microphone:
1. Open the speaker/microphone/charge
tab on top of your microTALK ® radio.
2. Insert the plug into the speaker/
microphone/charge jack. (See page 5 for
power output settings while using speaker/
microphones.)
To connect a wall charger/adapter:
1. Open the speaker/microphone/charge
tab on top of your microTALK ® radio.
2. Insert the wall charger/adapter plug
into the speaker/microphone/charge jack.
Rewind-Say-Again™
•
The Rewind-Say-Again feature on your microTalk ® radio can record
incoming or outgoing calls. Recorded calls will fill the memory
up to its 20-second capacity. As additional calls are recorded, the
oldest calls will be dropped from memory. To save recordings,
turn off the Rewind-Say-Again feature.
To turn on Rewind-Say-Again:
1. Press and hold the Rewind button until the
Rew icon illuminates.
The feature will remain on until turned off.
To turn off Rewind-Say-Again:
1. Press and hold the Rewind button until the
Rew icon is no longer illuminated.
Recording will be ended and the most recent 20
seconds of recording will be retained in memory.
To record incoming transmissions:
1. Turn on Rewind-Say-Again.
If Rewind-Say-Again is already on, incoming calls
will be recorded without further action on your part.
Speaker/Microphone/
Charge Jack
LI 7300
Rewind Button
Rewind Icon
CXR925_MANL.indd 6-7 7/15/09 5:12 PM