Citizen Systems CT-S2000DCL - Manual (Page 3)

5.6 Printing Paper
Also refer to the core dimension and notes of “5.2 Printing Paper” in User’s Manual of
standard model. Use print paper shown in the following table or the equivalent.
Paper type Product name
Recommended thermal label paper GG40/P22/G6B from Ojitac, HD75 from Nippon Paper,
150LA-1 from Ricoh
a) Label paper
Full cut
position
Paper feeding
direction
Printable area
CAUTION!
Pay attention to the following when using Auto Cutter. Otherwise, a cutter lock or a cutter
failure may occur.
■ Set the cut length of paper to 25 mm or more.
■ When using label paper, cut the gap between labels (liner sheet). Do not cut the label paper
(tack paper).
■ Adjusting the paper sensor must be carried when the type of liner is changed.
Mark Item Dimensions
A Liner width 57.5, 59.5, 79.5,
82.5 + 0.5
B Label width (Size A) -4 + 0.5
C Left edge of label 2 + 0.5
D Print width (Size A) - 4
E Top margin 2 + 1
F Print length 21 to 296
G Bottom margin 2 + 1
H Cut position between labels 1/2 x (Size I)
I Gap between labels 4 to 30
J Label length 25 to 300
K Label pitch I+J
Unit: mm
_
_
_
Black Mark (printed on the reverse)
b) Black mark paper (BM paper)
Cut position
Paper feeding
direction
Printable area
Unit: mm
CAUTION!
■ PCS value of black mark must be 0.9 or more.
■ When using the black mark paper, consider the margin of +/- 2 mm for the print position
against the standard position and +/- 5 mm for print length.
■ Refer to the above drawing for the printable area and have enough margings specified in the
marks E and G. If the print data size is out of the printable area, the printer should skip to next
page.
_
Dimensions
BM1 BM2 BM3
A Right edge of black mark 13.5 or more 57.5 or more 80.5 or more
B Left edge of black mark 15 or or less 15 oror less 15 or or less
C Black mark height 5
D Cut position in black mark 2.5
E Top margin 6.5
F Black mark pitch 30 to 300
G Bottom margin 9
Mark Item
_
TA74912-00F
1.00E-0710
Printed in Japan