Baumer BA OADM20I6 OADM21I6 - Manual (Page 49)

BA_OADM20I6_21I6_most.doc 49/88 Baumer
26.03.13 Frauenfeld, Switzerland
Time Description of timing functions Value Comment
t1
Minimum button hold time to enter
teach mode
5 s
Using the button, this feature can only be used
within 5 minutes after power-up. Using the
external teach input, it may be used at any
time.
t2
Maximum waiting time after teaching
the first position.
< 20 s
If the button has not been pushed during this
interval, the sensor will leave the teach mode
without any changes.
t3
LED on as response for the first
position.
approx 3 s
t4
Maximum waiting time after teaching
the second position.
< 20 s
If the button has not been pushed during this
interval, the sensor will leave the teach mode
without any changes.
t6
LED Blinking for “NOT OK response”
after teaching the second position.
approx 5 s
t7
Minimal time between high/low
transition of alarm output high/low
transition of the external teach input
at the beginning of the teach.
1 ms
t8
Pulse lengths on external teach input
for first position.
30..2000 ms
t9
Pulse lengths on external teach input
for second position.
30..2000 ms
t10
Delays between teach signal and
response on alarm output at the
rising edge of the signal.
< 20 ms
t11
Delay between teach signal and
response on alarm output at the
falling edge of the signal
< 10 ms
t12
Minimum blinking time for the reset
to factory settings with button.
10 s
t13
Blinking time after reset to factory
settings
> 0.2 s
As long as the button is down or the external
teach input is high.
t14
Minimum blinking time for the reset
to factory settings with external
teach input.
10 s
t15
Minimum high time of the external
teach input after the alarm output
has been set at the end of the
setting of the factory settings.
0.2 s