System configuration, Ventilation control – FRIGIDAIRE FRP77ETT3R User Manual
Page 8
SYSTEM CONFIGURATION
VENTILATION CONTROL
The ventilation control lever is located at left side of
unit, behind the front panel.
NOTE: The vent door shipping screw must be
removed before using vent control lever. See
Installation Instructions.
When set at CLOSE, only the air inside the room is
circulated and filtered.
When set at OPEN, outdoor air will be drawn
into room.
Energy Tip: Keep the vent control at CLOSE. Room
air will be filtered and circulated.
Fig. 13 – Ventilation Control Location
Vent Control
(Pull lever through label
to operate.)
ADJUSTING AIR DIRECTION FOR DUCTED INSTALLATIONS ONLY
To adjust air direction:
1. Remove front panel. See Fig. 10.
2. Remove louver screws that hold louver insert in place (from back side of front panel). See Fig. 14.
3. Turn louver insert and rotate 180°. See Fig. 18.
4. Replace louver insert.
5. Replace screws and front panel.
Fig. 14 – Backside of Front Panel
Louver screws
Louver screws
Fig. 15 – Adjusting Louvers
Air discharge upward
Air discharge outward (Default)
NOTE: Upward air direction should only be used on ducted installations.
Open
Close
2010 Electrolux Home Products, Inc.
All rights reserved.
8