FRIGIDAIRE FFEF4017LB - Manual (Page 26)

26
CARE & CLEANING
Special door care instructions - Most oven
doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are
fully in place.
2. Do not hit the glass with pots, pans, or any other ob-
ject.
3. Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of
breakage at a later time.
Figure 3
Figure 4
Oven door
Around
Hinge
CAUTION
The door is heavy. For safe, temporary storage, lay the
door fl at with the inside of the door facing down.
CAUTION
The door is heavy. For safe, temporary storage, lay the
door fl at with the inside of the door facing down.
Removing and replacing the main oven
door (some models)
To Remove Oven Door:
1. Open oven door completely (horizontal with fl oor -
See Figure 1).
2. Pull the door hinge locks on both left and right
door hinges down from the oven frame completely
towards the oven door (See Figure 2). A tool such as
a small fl at-blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle - See Figure 3).
4. Close the door to the broil stop position (the oven door
will stop into this position just before fully closing).
5. With the oven door in the broil stop position, lift the
oven door hinge arms over the roller pins located on
each side of the oven frame (See Figure 4).
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle - See Figure 3).
2. Holding the oven door at the same angle as the
removal position, seat the hook of the hinge arm over
the roller pins located on each side of the oven door
frame (See Figure 4). The hook of the hinge arms
must be fully seated onto the roller pins.
3. Fully open the oven door (horizontal with fl oor - See
Figure 1).
4. Push the door hinge locks up towards and into the
oven frame on both left and right oven door hinges
(See Figure 2) to the locked position.
5. Close the oven door.
Door Hinge locations
with oven door fully open
Figure 1
Figure 2
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and
engage it in the hinge levers. You may have to apply a
little downward pressure on the door to pull the locks
fully over the hooks.
3. Grab the door by the sides, pull the bottom of the
door up and toward you to disengage the hinge sup-
ports. Keep pulling the bottom of the door toward you
while rotating the top of the door toward the range to
completely disengage the hinge levers.
4. To replace the door, reverse the door removal steps.
Make sure the hinge supports are fully engaged before
unlocking the hinge levers.
To remove and replace the main oven
door (some models)