Before setting oven controls – FRIGIDAIRE FGB24T3ES User Manual

Page 7

Advertising
background image

7

BEFORE SETTING OVEN CONTROLS

Oven Vent Location

The oven is vented at the upper trim. When the oven is

on, warm air is released through the vent. This venting is

necessary for proper air circulation in the oven and good

baking results. do not block the vents. Doing so may

cause baking failures, fire or damage to the wall oven.

Air Circulation in the Oven

If using 1 rack, place in center of oven. If using multiple

racks, stagger cookware as shown.
For best air circulation and baking results allow 2-4"

(5-10cm) around the cookware for proper air circulation

and be sure pans and cookware do not touch each other,

the oven door, sides or back of the oven cavity. The hot

air must circulate around the pans and cookware in the

oven for even heat to reach around the food.

Arranging Oven Racks

ALWAYS ARRANGE OvEN RACKS WHEN THE OvEN IS

COOL (PRIOR TO OPERATING THE OvEN). Always use

oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it

stops. Lift up front of rack and slide out.
To replace an oven rack, fit the rack onto the guides

on the oven walls. Tilt the front of the rack upward and

slide the rack back into place.

Advertising
This manual is related to the following products: