FRIGIDAIRE FGEF304DKB - Manual (Page 12)

12
Multiple Oven Racks
Single Oven Rack
BEFORE SETTING OVEN CONTROLS
Air circulation in the oven
If using 1 rack, place in center of oven. If using multiple
racks, stagger cookware as shown.
For best air circulation and baking results allow 2-4"
(5-10 cm) around the cookware for proper air circulation
and be sure pans and cookware do not touch each other,
the oven door, sides or back of the oven cavity. The hot
air must circulate around the pans and cookware in the
oven for even heat to reach around the food.
Arranging Lower Oven Racks
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS
COOL (PRIOR TO OPERATING THE OVEN). Always use
oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it
stops. Lift up front of rack and slide out.
To replace an oven rack, fi t the rack onto the guides
on the oven walls. Tilt the front of the rack upward and
slide the rack back into place.
Recommended Rack Positions
Food Upper Oven Lower Oven
Broiling meats, chicken or fi sh 1 or 2 4
Cookies, cakes, pies, biscuits & muffi ns
Using a single rack 2 2 or 3
Using two racks - 2 and 4
Using multiple racks - 2, 3 and 4
Frozen pies, angel food cake, yeast, bread, 1
or 2 casseroles, small cuts of meat or poultry
1 or 2 1 or 2
Turkey, roast or ham - 1
Í NOTE
Always use caution when removing food from the oven.
4
3
2
1
Rack
positions
Oven vents
location
The upper oven is
vented at the back
of the cooktop and
the lower oven is
vented at the trim
between the ovens.
When an oven is on,
warm air is released
through its vent. This
venting is necessary for
proper air circulation
in the oven and good
baking results. DO
NOT BLOCK OVEN
VENTS. Never close
off the openings with
aluminium foil or any
other material.
CAUTION
Some models are equipped with a blower
which runs in baking and self-cleaning mode
to keep all internal components at a cool
temperature. The blower may keep running
even if the oven has been turned off, until the
components have cooled down.
1
2
3
4
Installing Upper Oven Rack Supports
To install oven rack support, insert it into the two brackets
on the oven wall interior and push down as shown in the
illustration to the right.
To remove the oven rack support for a self-clean cycle, pull
up the support to disengage it from the brackets.
Rack
positions
Upper Oven Rack Positions