FRIGIDAIRE FPRU19F8QF - Manual (Page 3)

Specifications
subject to change.
USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca
FPRU19F8Q 09/14 © 2014 Electrolux Home Products, Inc.
FPRU19F8QF 18.6 Cu. Ft.
All Refrigerator
All Refrigerator (18.6 Cu. Ft.)
with no water filter
Professional
Leveling System
(2) per unit raises height 2-9/16" min.
Only available with trim kits.
*Minimum depth from face of cabinet side panels
and requires recessed electrical outlet.
Built-In Installation
(without Trim Kit)
Single Unit
(A) 72" (B) 33" (C) 25 1 /
4
" min.*
Double Unit (Side-by-Side)
(A) 72" (B) 66" (C) 25 1 /
4
" min.*
Built-In Installation
(with Trim Kit & Leveling System)
Single Unit
(A) 75" or 79" (B) 33" (C) 25 1 /
4
" min.*
Double Unit (Side-by-Side)
(A) 75" or 79" (B) 66" (C) 25 1 /
4
" min.*
All-
Refrigerator
Cutout
Dimensions
Allow at
least 57 1 /
4
" with door in
90° open position
71 3 /
8
"
24 1 /
4
"
29" to handle
extension
Power
cord
location
(right
bottom
rear)
70 5 /
8
"
26 1 /
2
"
32"
Recessed electrical outlet
25"
Countertop
24"
Cabinet
25 1 /
4
" min. side panels,
1 /
2
" min. width
(Trim Kit installation requires
3 /
4
" min. width)
Optional Trim Kits
& Dimensions
Kits include top and side trim
pieces, louvered grille, reversible
kickplate and leveling system to
fit 75" or 79" opening height.
Single Louvered Trim Kit
PN # TRIMKITEZ1
(D) 75
1 /
8
" or 79 1 /
8
" (E) 34 3 /
4
"
Double Louvered Trim Kit
PN # TRIMKITEZ2
(Includes hardware to secure
side-by-side units together.)
(D) 75
1 /
8
" or 79 1 /
8
" (E) 67 1 /
8
"
Note: Both kits attach
directly to cabinetry through
top trim piece or louvered
grille to stabilize unit(s).
Refer to detailed kit installation
instructions packed with
kit or on web.
Louvered Grille
(for 79" opening)
(Single Trim Kit shown.)
B
C
A
Cut off
4" for 75"
opening
Top Trim Piece
(for 75" opening)
Trim Kit
E
D
4"
Reversible Kickplate
“Built-In Look” Specifications
• Minimum opening of 72" H x 33" W x 25-1/4" D required for single-
unit “Built-In Look” installation; 66" W required for double-unit
installation. (72" H to be measured from finished floor to underside
of soffit or overhead cabinet.)
• Remove all wall / floor molding prior to built-in installation.
Optional Trim Kit Specifications
• If optional Single or Double Louvered Trim Kit is to be used, different
cutout dimensions are required. Kit can be adapted to fit either 75"
or 79" opening height. (Refer to cutout dimensions on this page and
detailed Louvered Trim Kit installation instructions included with kit
or on web.)
• Remove all wall / floor molding prior to built-in installation.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
• Single Louvered Trim Kit – (PN # TRIMKITEZ1).
• Double Louvered Trim Kit – (PN # TRIMKITEZ2).
• PureAdvantage® Air Filter
Replacement Cartridge – (PN # 241754001).
Built-In All-Refrigerator Specifications
• Product Shipping Weight – 240 Lbs.
• An electrical supply with grounded three-prong receptacle is required.
The power supply circuit must be installed in accordance with current
edition of National Electrical Code (NFPA 70) and local codes &
ordinances.
• Voltage Rating – 115V / 60 Hz / 20 Amps
• Connected Load (kW Rating) @ 115 Volts = 0.55 kW
• Amps @ 115 Volts = 5 Amps
• Always consult local and national electric codes.
• Minimum 25-1/4" depth requires recessed electrical outlet.
• To allow for ease of installation, tape excess power cord to back of unit.
• When installing refrigerator adjacent to wall, cabinet or other appliance
that extends beyond front edge of unit, 20" minimum clearance
recommended to allow for optimum 140° door swing, providing
complete drawer / crisper access and removal. (Absolute 4" minimum
clearance will ONLY allow for 90° door swing which will provide limited
drawer / crisper access with restricted removal.)
• Refrigerator must be placed on level surface of hard material, same
height as flooring. Surface must support approximately 800 lbs. when
fully loaded. Unit equipped with 4-point leveling.