FRIGIDAIRE FGGS3045KF - Manual (Page 3)

30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
3
Before installing the unit, measure the heights of the two (2)
cabinet sides (H1-4), front and back (see illustration 1) from the
floor to the top of the counter.
H1
H2
H3
H4
To avoid breakage: Do NOT handle or
manipulate the unit by the cooktop.
The counter-top around the cut-out should be flat and leveled
(see hatched area on illustration 1).
1
2
3
Illustration 1
Shave
Raised
Edge
to Clear
Space for a
31½" (81 cm)
1 ½" Max.
(3.8 cm Max.)
Wide Cooktop.
Illustration 2
Level the range using the
four (4) leveling legs, so
that the height from the
floor to the underside of
the metal flange is greater
than the tallest cabinet
measurement by at least
1/16" (see illustration 2).
7
Remove the protective channels on each side of the cooktop (if
provided).
Slide the unit into the cabinet. Make sure the center of the unit is
aligned with the center of the cabinet cut-out.
5
6
4
The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The cooktop
should NOT rest directly on the countertop (see illustration 2) or else
it could cause damage to the cooktop voiding the warranty. Level the
unit if needed.
After the installation, MAKE SURE that
the unit is supported by the two front
leveling legs and the two adjustable
leveling wheels
and NOT by the
cooktop.
Metal Flange
To successfully
install the range,
the initial level
height from floor
to underside of
cooktop frame
should be at least
1/16" taller than
cabinet sides as
measured in step
2.