FRIGIDAIRE FGGF3032MB - Manual (Page 7)

7
oven vent location
Fig. 1
Recommended oven rack positions by food type
Food type
Position
Broiling meats See broil
Cookies, cakes, pies, biscuits & muffins 3 or 4
Frozen pies, angel food cake, yeast, bread
and casseroles 1 or 2
Small cuts of meat or poultry 1 or 2
Turkey, roast or ham 1
Removing, replacing & arranging most oven
racks types
Arranging - always
arrange oven racks when
the oven is cool (prior to
operating the oven).
Fig. 4
Fig. 5
Oven rack stop
Oven rack positions - Fig. 2
Oven vent location
The oven vent is located below the control panel (Fig. 1).
When the oven is heating, warm air passes through this
vent. This venting is necessary for proper air circulation in
the oven which helps to provide good baking results. Do
not block the oven vent.
2
3
4
5
6
1
Always use oven mitts to protect hands from possible
burns when using the oven or cooktop. The oven, oven
racks and cooktop will become very hot.
CAUTION
Oven racks
Do not remove or attempt to arrange oven racks with
cookware still on the racks. To avoid damaging cookware
or spilling food items, always remove any cookware first.
IMPORTANT
rack
guides
Fig. 3
Most flat and offset oven racks slide on rack guides
provided along the oven cavity sides. For better access to
food items in the oven, slowly pull the oven rack straight
out to the oven rack stop position before checking on food
items or removing food dishes from the oven (Fig. 3).
The rack guides are curved near the front of each guide.
The curve will catch and hold the oven rack stable into a
stop position when an oven rack is extended straight out
from the oven.
To remove - Pull the
oven rack straight out
until it reaches the stop
position.Tilt up front of
oven rack to slide past
the stop position and pull
the rack out of the oven
cavity (Fig. 4).
To replace - Rest the
oven rack evenly
between one of the left
and right front guides
along the oven walls. Be
sure to place using left
and right oven guides
that will hold the oven
rack level. Tilt front of
rack upward and slide
rack in past the stop
position.Then bring the
rack to a level position
and slide the rack
completely inside of the
oven (Fig. 5).
BEFORE SETTING OVEN CONTROLS