FRIGIDAIRE FGGF301DNW - Manual (Page 3)

Specifications
subject to change.
USA • 10200 David Taylor Drive • Charlotte, NC 28262 • 1-800-FRIGIDAIRE • frigidaire.com
CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.ca
FGGF301DN 12/13 © 2013 Electrolux Home Products, Inc.
Freestanding Ranges
FGGF301DN F/ W/ B 30" Gas
Freestanding Range Specifications
• Product Shipping Weight (approx.) – 260 Lbs.
• Voltage Rating – 120V / 60 Hz / 15 Amp
• Connected Load (kW Rating) @ 120 Volts = 1.8 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
• Amps @ 120 Volts = 15 Amps
• Always consult local and national electric and gas codes.
• Make sure wall coverings around range can withstand heat generated
by range.
• Linoleum or any other synthetic floor covering located beneath range,
must be capable of withstanding minimum heat of 90° F above room
temperature without shrinking, warping or discoloring. Insulating pad
or 1/4"-thick plywood required between range and a carpeted floor.
• Do not obstruct flow of combustion air at oven vent nor around base
or beneath lower front panel of range. Range requires fresh air for
proper burner combustion.
• Do not install range beneath any downward-blowing, overhead vent
hood or air curtain.
• Range ships with 1/2" NPT factory regulator.
• Range is LP Gas convertible. (Optional LP Gas Conversion
Kit available.)
• Overhead cabinetry should not exceed a 13" maximum depth.
• Allow 30" minimum clearance between top of cooking surface and
bottom of unprotected wood or metal overhead cabinet; or 24"
minimum clearance when bottom of wood or metal overhead cabinet
is protected by not less than 1/4" flame-retardant millboard covered
with not less than No. 28 MSG sheet steel, 0.015" stainless steel,
0.024" aluminum or 0.020" copper.
• Absolute minimum horizontal distance between overhead cabinets
installed to either side of appliance must be no less than maximum
width of appliance.
• Range can be installed flush to wall with 0" minimum rear clearance.
• Minimum 7" clearance required from edge of rangetop to nearest
combustible wall on either side of range above 36" height.
• To reduce risk of fire when using overhead cabinetry, install vent hood
that projects horizontally a recommended minimum of 5" beyond
bottom of cabinets.
• Follow all dimension requirements provided to prevent property
damage, potential fire hazard, and incorrect countertop and
cabinet cuts.
Optional Accessories
• LP Gas Conversion Kit – (PN # 318565419)
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
30" Gas Freestanding Ranges with Double Ovens (Upper)
Gallery